|
Who's Online
There currently are 5883 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent service manual includes everything is need to repair this radio-caseete, how to disassemble, wiring diagram, all , waiting time until the download was only a few hours. I'm going to buy service manuals from here, are cheap and very good.Thank you.
;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
Disc Sensor Adjustment Be sure to perform this adjustment after sensor adjustment in MECHANICAL ADJUSTMENT. Connection:
MAIN board CN506 D.S GND T.P D.S: Pin 1 T.P: Pin 3 GND: Pin 2 oscilloscope
5. Rotate the DISC/CHARACTER knob in the counterclockwise direction and the disc table starts to rotate in the same direction. Check that the waveform at this time is the same as that in step 4. If larger by a considerable extent, rotate the DISC/CHARACTER knob in the clockwise direction and the disc table starts to rotate in the same direction. Repeat from step 4. 6. Rotate RV501 of the MAIN board and adjust so that the H and L portions of the D.S waveform become the same.
Waveform:
D.S
D.S
Adjust so that these widths become the same.
Adjustment Location: MAIN board
P.T
1. Connect the oscilloscope to Pins 1, 2, and 3 of CN506 of the MAIN board. 2. Check that no discs are loaded in the unit. 3. With the power ON, while pressing the GROUP 5 and § OPEN/CLOSE buttons, press the +100 button. The disc table starts to rotate in the clockwise direction. 4. Loosen the fixing screw, move the mounting board (SENSOR), and secure the mounting board (SENSOR) at the point the H portion of the P.T waveform comes the center of the H portion of the D.S waveform.
Fixing screw Mounting board (SENSOR)
D.S
P.T
Should be at the center
� 18 �
|
|
|
> |
|