|
There are currently no product reviews.
 ;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
CDP-CE575 SECTION 4 ASSEMBLY
Note: Follow the assembly procedure in the numerical order given.
ADJUSTING PHASE OF SWING GEAR AND GEAR (U/D)
5 stopper washer (FR) 4 Push fully the shaft of shaft gear and align the hole shape of gear (loading B). 3 Let the swing gear through under the chassis h and engage its dowel g with the groove f of rotary encoder. 6 screw (PTPWH M2.6)
g
2 Install the rotary encoder so that its groove f comes to the position shown in the figure.
f h
1 Insert the shaft gear up to the position where its shaft comes out by 5 mm.
circle mark
circle mark 8 screw (PTPWH M2.6)
gear (RV) swing gear Fig. A 7 gear (U/D) q; screw (PTPWH M2.6)
9 gear (RV) Note: Align swing gear, a circle mark on the gear (U/D), and the teeth of gear (RV) to the position showing in the Fig. A.
13
|
