The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
It's a grate service manuals.Have many details and the writing it's so clear.You have all you want in manual,nothing missing,belive me.I'm verry satisfied of this manual.
Text excerpt from page 13 (click to view)
2-8. R Signal De-matrix Adjustment 2-9. G Signal De-matrix Adjustment
2-8. R Signal De-matrix Adjustment
Measurement equipment Waveform monitor Procedure 1. Check to see that S505 is set to RGB. 2. Supply 100% color bars signal from the signal generator to the SDI IN connector. 3. Set the waveform monitor as follows. MODE : WAVEFORM INPUT : CH3 REF : EXT 4. Adjust 1RV305 so that the level A satisfies the specification. Use 1RV303 in the fine adjustment so that the peak of each level is flat. n Do not set S505 to YUV until �2-9. G Signal Dematrix Adjustment� is completed. Measuring point : R-Y/R connector (BKPF-102CB connector panel) Adjustment point : 1RV303 (F-6)/DAC-30 (for fine adjustment) 1RV305 (H-6)/DAC-30
2-9. G Signal De-matrix Adjustment
n Adjust the G signal after the B signal (section 2-7) and R signal (section 2-8) adjustments are completed. Measurement equipment Waveform monitor Procedure 1. Check to see that S505 is set to RGB. 2. Supply 100% color bars signal from the signal generator to the SDI IN connector. 3. Set the waveform monitor as follows. MODE : WAVEFORM INPUT : CH1 REF : EXT 4. Adjust 1RV404 so that the level A satisfies the specification. 5. Set S505 to YUV. Measuring point : Y/G connector (BKPF-102CB connector panel) Adjustment point : 1RV404 (H-5)/DAC-30